Table of Contents
Advertisement
Limit who can access your router.
3
Don't enable any local service (such as NTP) that you don't use. Any enabled service could present
4
a potential security risk. A determined hacker might be able to find creative ways to misuse the
enabled services to access the firewall or the network.
For local services that are enabled, protect against misuse. Protect by configuring the services to
5
communicate only with specific peers, and protect by configuring rules to block packets for the
services at specific interfaces.
Protect against IP spoofing by making sure the firewall is active.
6
Keep the firewall in a secured (locked) room.
7
16.2 General Screen
Use this screen to enable or disable the EMG3425-Q10A's firewall, and set up firewall logs. Click
Security > Firewall to open the General screen.
Figure 71 Security > Firewall > General l
The following table describes the labels in this screen.
Table 49 Security > Firewall > General
LABEL
Enable Firewall
Apply
Cancel
16.3 Services Screen
If an outside user attempts to probe an unsupported port on your EMG3425-Q10A, an ICMP
response packet is automatically returned. This allows the outside user to know the EMG3425-Q10A
exists. Use this screen to prevent the ICMP response packet from being sent. This keeps outsiders
from discovering your EMG3425-Q10A when unsupported ports are probed.
You can also use this screen to enable service blocking, enter/delete/modify the services you want
to block and the date/time you want to block them.
Click Security > Firewall > Services. The screen appears as shown next.
Chapter 16 Firewall
DESCRIPTION
Select this check box to activate the firewall. The EMG3425-Q10A performs access control
and protects against Denial of Service (DoS) attacks when the firewall is activated.
Click Apply to save the settings.
Click Cancel to start configuring this screen again.
EMG3425-Q10A User's Guide
119
Advertisement
Table of Contents
