Table of Contents
Advertisement
5.3.1 Setting your EMG3425-Q10A to AP Mode
Log into the Web Configurator if you haven't already. See the Quick start Guide for instructions on
1
how to do this.
To use your EMG3425-Q10A as an access point, go to Maintenance > Sys OP Mode and select
2
Access Point Mode.
Figure 12 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your EMG3425-Q10A is already in Access Point mode.
When you select Access Point Mode, the following pop-up message window appears.
3
Figure 13 Pop up for Access Point mode
Click OK. Then click Apply. The Web Configurator refreshes once the change to Access Point mode
is successful.
5.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
Connect your computer to the LAN port of the EMG3425-Q10A.
1
The default IP address of the EMG3425-Q10A is "192.168.1.2". In this case, your computer must
2
have an IP address in the range between "192.168.1.3" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
3
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix B on page 203
Chapter 5 Access Point Mode
for information on changing your computer's IP address.
EMG3425-Q10A User's Guide
32
Advertisement
Table of Contents
