Table of Contents
Advertisement
Table 17 Network > WAN > Internet Connection: PPPoE Encapsulation (continued)
LABEL
DESCRIPTION
VID
Enter a VLAN identifier between 11 to 4094 (the 802.1Q tag specifies only a priority and
is referred to as a priority tag).
VID 1 (the default VLAN ID) is reserved for a management VLAN.
Note: This field is not available when you are configuring the default WAN entry.
PPP Information
PPP Username
Type the user name given to you by your ISP.
PPP Password
Type the password associated with the user name above.
MTU Size
Enter the Maximum Transmission Unit (MTU) or the largest packet size per frame that
your EMG3425-Q10A can receive and process.
PPP Auto Connect
Select this option if you do not want the connection to time out.
Idle Timeout
This value specifies the time in minutes that elapses before the router automatically
(second)
disconnects from the PPPoE server.
PPPoE Service
Enter the PPPoE service name specified in the ISP account.
Name
WAN IP Address Assignment
Get automatically
Select this option If your ISP did not assign you a fixed IP address. This is the default
from ISP
selection.
Use Fixed IP
Select this option If the ISP assigned a fixed IP address.
Address
My WAN IP
Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Address
6RD
Use IPv6 Rapid Deployment (6rd) when the local network uses IPv6 and the ISP has an IPv4 network. When
the EMG3425-Q10A has an IPv4 WAN address and you set IPv6/IPv4 mode to IPv4 Only, you can enable 6rd
to encapsulate IPv6 packets in IPv4 packets to cross the ISP's IPv4 network.
The EMG3425-Q10A generates a global IPv6 prefix from its IPv4 WAN address and tunnels IPv6 traffic to the
ISP's Border Relay router to connect to the native IPv6 Internet. The local network can also use IPv4 services.
The EMG3425-Q10A uses its configured IPv4 WAN IP to route IPv4 traffic to the IPv4 Internet.
This is available only when you select IPv4 Only in the IPv6/IPv4 field.
Enable 6RD
Enable IPv6 rapid deployment to tunnel IPv6 traffic from the local network through the
ISP's IPv4 network.
Automatically
Select this to have the EMG3425-Q10A detect the relay server's IP address automatically
configured by
through DHCP.
DHCPC
Manually
Select this if you have the IPv4 address of the relay server.
Configured
Border Relay IPv4
Specify the relay server's IPv4 address.
Address
Service Provider
Enter an IPv6 prefix for tunneling IPv6 traffic to the ISP's Border Relay router and
IPv6 Prefix
connecting to the native IPv6 Internet.
Service Provider
Enter the IPv6 prefix length.
IPv6 Prefix length
An IPv6 prefix length specifies how many most significant bits (starting from the left) in
the address compose the network address.
IPv4 mask length
Enter the subnet mask number (1~32) for the IPv4 network.
DNS Server
Chapter 8 WAN
EMG3425-Q10A User's Guide
66
Advertisement
Table of Contents
