Table of Contents
Advertisement
Procedure
1. Create a DLCI on the router virtual port.
Configuration → Vitual Router Ports → DLCI Records
Assign the DLCI number that will be used for management on Serial port 0
(Rtr-S0 – e.g., DLCI 900).
2. Create a management PVC using the DLCI just configured on Serial port 0
to connect the management link to the router.
Configuration → Management and Communication → Management PVCs
Using the DLCI 900 example, make the following connection:
— Select Name: Mgmt900
— Intf IP Address: Special, and add the IP address for the Ethernet interface in
Step 5
on page 18 of
— Intf Subnet Mask: Special, and add the Subnet Mask for the Ethernet interface
in
Step 5
— Set DE: Leave at the default, Disable.
— Primary Link: Select Rtr-S0.
— Primary DLCI: Select 900.
3. Return to the Main Menu and press Shift-r to access the router's CLI.
4. From the CLI, enable password and show the router's configuration.
en
show config
A list of the router's configuration is shown, most of the configuration already
completed using the default values.
interface serial 0.900
ip unnumbered
frame-relay interface-dlci 900
no bridge-group 1
exit
5. Add the route to the routing table.
config t
ip route 10.101.51.253 255.255.255.255 Serial 0.900
save
exit
6. Ping the Ethernet management interface to verify that the router can be reached.
ping 10.101.51.253
exit
The router is now set up for in-band management.
Using the Easy Install Feature
on page 18 of
Using the Easy Install Feature
20
.
.
Advertisement
Table of Contents
