System and Test Status Messages
To access System and Test status information:
The following information is included on this screen:
Self-Test Results Messages
Self-test result messages shown in
in the Self-Test Results field at the top of the System and Test Status screen.
Table 7-5.
Last Reset
The Last Reset field provides the last date and time that the FrameSaver unit was
reset. This field is located after the Self-Test Results field at the top of the System
and Test Status screen.
9700-A2-GB20-20
Main Menu
Status
Self-Test Results Messages
Last Reset
Health and Status Messages
Test Status Messages
NOTE:
Status messages in the following sections are in alphabetical order.
Self-Test Results Messages
Message
What It Indicates
Failure xxxxxxxx
An internal failure occurred
(xxxxxxxx represents an
8-digit hexadecimal failure
code used by service
personnel).
Record the failure code
before resetting the unit;
otherwise, the error
information will be lost.
Passed
No problems were found
during power-on.
Main Menu
Status
December 2002
System and Test Status
Table 7-5, Self-Test Results Messages
What To Do
1. Record the failure code.
2. Reset the unit.
3. If problem still exists, contact
No action needed.
System and Test Status
7. Operation and Maintenance
appear
your service representative.
7-19