Figure 12-21 Securing The Smart Card Reader Interface Cable Into The Reader Cable Clip - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Reader cable clip
Securing the Smart Card Reader Interface Cable into the Reader Cable Clip
FIGURE 12-21
11. Inspect the smart card reader bracket fasteners to verify that:
The drive rails are well seated on the smart card reader bracket.
■
The bracket is tight in the removable media bay.
■
12. If you installed the smart card reader bracket after replacing the interface cable,
return to Step 6 of
13. Inspect the smart card reader cabling to verify that:
The smart card reader interface cable is firmly connected to the motherboard at
■
SCR0.
The interface cable is firmly connected to smart card reader.
■
The interface cable is secure in the reader cable clip
■
14. Install the bezel, the access panel, power on the system, and verify the smart card
reader installation.
Refer to:
"Installing the Bezel" on page 15-2
■
"Installing the Access Panel" on page 15-5
■
"Powering On the Workstation" on page 15-8
■
SCR0
"Installing the Smart Card Reader Cable" on page
Chapter 12 Replacing Storage Devices
14-5.
12-23