Routing clip
FIGURE 11-44
9. Disconnect the following power and signal cables from the corresponding
motherboard connectors and set them out of the way of the motherboard.
See
FIGURE 11-43
Power supply cables at connectors PS0, PS1, and PS2
■
IDE power at connector IDE PWR
■
Power button at connector J24 SW0
■
Front fan at connector FAN0 SYS
■
Rear fan at connector FAN1 SYS (if the rear fan was not removed)
■
Front audio at connector J13 AUDIO
■
Speaker at connector SPK0
■
10. Disconnect the following interface cables from the corresponding motherboard
connectors and set them out of the way of the motherboard.
See
FIGURE 11-43
Smart card reader at connector SCR0
■
Hard drive at connector IDE PRI
■
Optical drive at connector IDE SEC
■
Front USB at connector J19 USB
■
11-48
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Power
supply
cables
Removing Cables From the Clips
.
.
Reader cable clip
SCR0
J24 SW0
FAN0 SYS
SPK0
J19 USB
J13 Audio
Bezel cable clip
I/O cable clip