Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual page 274

"Installing the Chassis Cross Brace" on page 13-53
■
"Installing the PCI Card Support" on page 13-47
■
19. Inspect the motherboard and other component fasteners to verify that:
The DIMM ejectors are upright and tight.
■
The rear fan bracket feet are well seated in the chassis.
■
20. Inspect the motherboard cabling to verify that:
Smart card reader cable at connector SCR0
■
Hard drive interface cable at connector IDE PRI
■
Optical drive interface cable at connector IDE SEC
■
Front USB cable at connector J19 USB
■
Power supply cables at connectors PS0, PS1, and PS2
■
IDE power cable at connector IDE PWR
■
Power switch cable at connector J24 SW0
■
Front fan cable at connector FAN0 SYS
■
Rear fan cable at connector FAN1 SYS (if the rear fan was not removed)
■
Front audio cable at connector J13 AUDIO
■
Speaker cable at connector SPK0
■
The cables are secure in the clips.
■
21. Install the access panel, power on the system, and verify the motherboard
installation.
Refer to:
"Installing the Access Panel" on page 15-5
■
"Powering On the Workstation" on page 15-8
■
"Verifying an Installation" on page 15-11
■
11-58 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004