Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual page 282

FIGURE 12-6
6. Verify that the hard drive configuration jumpers are set to Cable Select or CS.
Refer to the hard drive documentation for configuration instructions.
7. Install the hard drive.
See
FIGURE 12-3
8. Slide the hard drive into the hard drive bay until the drive rail tabs click.
9. Connect the hard drive interface cables to the installed hard drives.
Connect the boot drive to the connector labeled HDD0 at the end of the interface
cable. If a second drive is installed, attach the connector labeled HDD1 to it. See
FIGURE 12-7
Connector
IDE PWR
Connector
IDE PRI
FIGURE 12-7
12-8 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Drive rail
HDD-L
Tab L
Interface connector
Configuration jumpers
Installing the Drive Rails
. Place the boot drive into the upper drive bay HDD0.
.
Interface cable
Installing the Hard Drive Cables
Hard drive
Drive rail
HDD-R
Tab R
IDE power connector
Connectors for
HDD0
IDE power cable