Re-Entering The Server Serial Number And Product Id; Power Backplane - HP ProLiant DL980 G7 Maintenance And Service Manual

4. Slide the server back into the rack.
5. Power up the server.
After you replace the system board, you must re-enter the server serial number and the product ID.
1. During the server startup sequence, press the F9 key to access RBSU.
2. Select the Advanced Options menu.
3. Select Service Options.
4. Select Serial Number. The following warnings appear:
WARNING! WARNING! WARNING! The serial number is loaded into the system during the
manufacturing process and should NOT be modified. This option should only be used by
qualified service personnel. This value should always match the serial number sticker located
on the chassis.
Warning: The serial number should ONLY be modified by qualified personnel. This value
should always match the serial number located on the chassis.
5. Press the Enter key to clear the warning.
6. Enter the serial number and press the Enter key.
7. Select Product ID. The following warning appears:
Warning: The Product ID should ONLY be modified by qualified personnel. This value should
always match the Product ID on the chassis.
8. Enter the product ID and press the Enter key.
9. Press the Esc key to close the menu.
10. Press the Esc key to exit RBSU.
1 1. Press the F10 key to confirm exiting RBSU. The server automatically reboots.

Re-entering the server serial number and product ID

After you replace the SPI board, you must re-enter the server serial number and the product ID.
1. During the server startup sequence, press the F9 key to access RBSU.
2. Select the Advanced Options menu.
3. Select Serial Number. The following warning is displayed:
Warning: The serial number should ONLY be modified by qualified service personnel. This
value should always match the serial number located on the chassis.
4. Press the Enter key to clear the warning.
5. Enter the serial number.
6. Select Product ID. The following warning is displayed:
Warning: The Product ID should ONLY be modified by qualified service personnel. This value
should always match the Product ID located on the chassis.
7. Enter the product ID, and press the Enter key.
8. Press the Esc key to close the menu.
9. Press the Esc key to exit RBSU.
10. Press the F10 key to confirm exiting RBSU. The server automatically reboots.

Power backplane

To remove the component:
1. Power off the server
2. Extend the server from the rack.
3. Remove the access panel.
4. Remove all power supplies
5. Remove the XNC module
70 Removal and replacement procedures
("Power off the server" (page
("Hot-plug power supply" (page
("XNC module" (page
22)).
24)).
67)).