HP ProLiant DL980 G7 Maintenance And Service Manual page 69

1. Power off the server
2. Remove the server from the rack.
3. Remove the access panel.
4. Remove the processor memory drawer
or processor memory drawer blank" (page
5. Disconnect all cables from all installed expansion boards.
6. Remove all expansion boards
7. Remove the SPI board
8. Remove the I/O expansion board, if installed.
9. Remove the system board.
To replace a system board:
1. Install the spare system board.
2. Replace all components removed from the failed system board.
3. Install the access panel.
("Power off the server" (page
("Remove the upper or lower processor memory drawer
("Non-hot-plug expansion board" (page
("Remove the SPI board" (page
22)).
26)).
56)).
52)).
System board 69