System Board - HP ProLiant DL980 G7 Maintenance And Service Manual

3. Lower the handle, and then remove the component from the server.
CAUTION:
CPU board or XNC boards with new components at the same time.
CAUTION:
updated
component.
CAUTION:
Failure to cable the XNC will result in the lower processor memory drawer not being recognized
by the server.
To replace the component, reverse the removal procedure.

System board

WARNING!
risk of injury due to the weight of the server, remove the following components before removing
the server from the rack:
Processor memory module
Hard drives
Power supplies
The server weighs 21.8 kg (48 lb) with these components removed and might require two
people to remove the server from the rack.
CAUTION:
electrostatic discharge
CAUTION:
board. If you believe the system board requires replacement, contact HP Technical Support before
proceeding.
68 Removal and replacement procedures
Do not replace either the SPI board, main I/O board, upper CPU board, lower
If replacing this component with a new part, all component firmware must be
("Flashing firmware using Smart Components" (page
XNC cabling ("XNC cabling" (page
The server weighs approximately 72.6 kg–93 kg (160 lb–205 lb). To reduce the
Before starting this procedure, read the information about protecting against
("Preventing electrostatic discharge" (page
Only authorized technicians trained by HP should attempt to remove the system
77)) before replacing any other
102)) is required for eight processor systems.
21)).