Processor - HP ProLiant DL980 G7 Maintenance And Service Manual

5. Install the processor memory drawer cover.
6. Install the processor memory drawer.
7. Power up the server.
To replace the component, reverse the removal procedure.

Processor

WARNING!
memory module. The processor memory module is very heavy when fully populated.
CAUTION:
Failure to cable the XNC will result in the lower processor memory drawer not being recognized
by the server.
CAUTION:
CAUTION:
without using the processor installation tool.
CAUTION:
configurations must contain processors with the same part number.
To remove the component:
1. Power off the server
2. Remove the processor memory drawer
or processor memory drawer blank" (page
CAUTION:
of the processor memory drawer is fully open before removing the cover.
3. Remove the processor memory drawer cover
(page 27)).
44 Removal and replacement procedures
Use caution when installing the processor memory module or removing the processor
XNC cabling ("XNC cabling" (page
Use care when handling components to avoid damaging connector pins.
To help avoid damage to the processor and system board, do not install the processor
To prevent possible server malfunction and damage to the equipment, multiprocessor
("Power off the server" (page
To prevent damage to the processor memory drawer cover, be sure the handle
102)) is required for eight processor systems.
22)).
("Remove the upper or lower processor memory drawer
26)).
("Remove a processor memory drawer cover"