Beep Level - Icom ID-51A Advanced Manual

Previous view
16
MENU SCREEN
■ Sounds items (Continued)

Beep Level

Sounds > Beep Level
Select a beep audio output level between 0 (OFF), 1 (minimum) and 9 (maxi-
mum).
Beep/Vol Level Link
Sounds > Beep/Vol Level Link
Select whether or not the beep output level can be adjusted by the [VOL]
control.
• OFF: The output level is fixed to the level set in Beep Level.
• ON: The output level can be adjusted by rotating [VOL].
Key-Touch Beep
Sounds > Key-Touch Beep
Turn the confirmation beep tones ON or OFF.
• OFF: Turns the function OFF for silent operation.
• ON: A beep sounds when a key is pushed.
NOTE: The beep tone sounds regardless of this setting when:
- the power is turned ON
- a matched tone signal is received if the pocket beep is activated.
- the transceiver is automatically turned OFF. (The beep sounds before
powering OFF.)
- TOT (Time-Out Timer) function is activated. (Approximately 10 seconds
before the Time-Out Timer cuts off transmission.)
- the cloning read or write operation starts or finishes.
- a received signal stops the scan. (Scan Stop Beep)
- the communicating station finishes transmitting or the receive signal dis-
appears while in the digital mode operation. (Standby Beep)
Home CH Beep
Sounds > Home CH beep
Turn the Home CH Beep ON or OFF.
• OFF: No beep.
• ON: When the specified Home CH is selected by rotating [DIAL], a beep
sounds.
NOTE: The Home CH frequency, memory or repeater can be respectively
selected. (p. 17-5)
16-89
(Default: 3)
(Default: OFF)
(Default: ON)
(Default: ON)