Setting The Beep Level - Icom IDAS F3201DEX 14 Operating Instructions Manual

3
BASIC OPERATION

Setting the beep level

You can adjust the beep level between 1 and 5, or 1
(linked) and 5 (linked).
When a linked option is selected, you can adjust the
beep level by rotating [VOL].
Rotate [VOL] to turn OFF the transceiver power.
q
Set [ROTARY SELECTOR] to any channel other
w
than Channel 16.
While holding down [Lower], rotate [VOL] to turn
e
ON the power and enter the beep level adjustment
mode.
Push [Upper] to change the beep level as shown to
r
the right.
• A beep sounds every time you push [Upper]. Therefore,
you can determine the current level setting by the in-
creasing loudness of the beep that sounds.
• To determine if you have selected a linked level, set [VOL]
to minimum, then push [Upper] repeatedly, listening for
the loudest beep (level 5). Pushing [Upper] once after the
loudest beep will select 1 (Linked). Repeatedly push [Up-
per] to select the desired linked level.
Rotate [VOL] to turn OFF the power to exit the beep
t
level adjustment mode.
NOTE: This operation may not be available, depend-
ing on the presetting.
[Upper]
[Lower]
3-8
[ROTARY SELECTOR]
[VOL]
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Upper]
5
4
3
2
1