Dr Scan And A Priority Channel - Icom ID-51A Advanced Manual

Previous view
14
PRIORITY WATCH

■ DR scan and a priority channel

Checks the selected priority channel every 5 seconds,
during a DR scan.
1. Set the priority channel
• To select a VFO frequency
q Push [V/MHz]
w Rotate [DIAL] to set the receive frequency.
• To select a Memory channel
q Push [M/CALL]
w Rotate [DIAL] to select the Memory channel you
want to watch.
• To select a Bank channel
q Push [M/CALL]
w Rotate [DIAL] to select the Bank channel you
want to watch.
How to select the Memory and Bank:
z In the Memory mode, push [QUICK]
x Push D-pad() to select "Bank Select," and
then push D-pad(Ent).
• The Bank list is displayed.
c Push D-pad() to select a desired bank and
then push D-pad(Ent).
• If "OFF" is selected, the bank selection is can-
celed.
D-pad
(Ent)
( )
• To select a Call channel
q Push [M/CALL]
the Call channel mode.
w Rotate [DIAL] to select the Call channel you want
to watch.
2. Start the DR scan
q Hold down for 1 second.
• The DR screen appears.
w Hold down [SCAN]
e Push D-pad( ) to select the repeater type, and

then push D-pad(Ent).
• The DR scan starts.
3. Start the Priority watch
q Push [QUICK] .
w Push D-pad( ) to select "PRIO Watch," and then

push D-pad(Ent).
e Push D-pad() to select "ON" or "Bell."
• ON: When a signal is received on the priority chan-
nel, the channel is automatically selected.
• Bell: When a signal is received on the priority chan-
nel, the " " icon is displayed.
r Push D-pad(Ent) to start the Priority watch.
• The "PRIO" icon appears
to select the VFO mode.
to select the Memory mode.
to select the Memory mode.
.
one or more times to select
for 1 second.
Example: Checks "145.800 MHz" every 5 seconds, dur-
ing the DR scan.
The DR scan starts.
Blinks
NOTE:
• You can start the Priority watch (Step 3) before start-
ing the DR scan (Step 2).
• Push [CLR] to cancel the Priority and the DR scan.
14-16
Rotate [DIAL] to set the
receive frequency.
Hold down
for 1 second.
Hold down [SCAN]
for 1 second.
Push D-pad() to se-
lect the repeater type,
then push D-pad(Ent).
Push [QUICK]
Push D-pad() to
select, then push
D-pad(Ent).
Push D-pad() to
select, then push
D-pad(Ent).
[DIAL]
☞ Continued on the next page.
.