Icom ID-51A Advanced Manual page 124

Previous view
9
D-STAR OPERATION <ADVANCED>
■ Entering information into Repeater List
D New repeater entry (Continued)
6. Entering the gateway repeater call sign
The 8th digit in the call sign, entered in [5. Entering
the repeater call sign] is automatically set to "G" as
the gateway port. You can skip this setting and go to
the next item. If you need to change it, follow the steps
described below.
@5 Push D-pad( ) to select "GW CALL SIGN," and then

push D-pad(Ent) to enter the gateway repeater call
sign edit mode.
D-pad
(Ent)
( )
@6 Rotate [DIAL] to select the first character.
• A to Z, 0 to 9, / and a space can be selected.
• A space can be entered in any input mode.
• Push [CLR] to delete the selected character, or hold
down [CLR] to continuously delete the characters,
first to the right, and then to the left of the cursor.
@7 Push D-pad() to move the cursor to the second
digit.
@8 Repeat steps @6 and @7 to enter a name of up to 8
characters, including spaces.
• The 8th digit in the gateway repeater call sign is set to
only "G" or a space.
@9 After entering the gateway repeater call sign, push
D-pad(Ent).
7. Viewing the repeater group
In this item, you can view the repeater group that is
selected in [1. Selecting the repeater group]. You can
skip this setting and go to the next item.
If necessary, you can change the repeater group.
#0 Push D-pad( ) to select "GROUP," and then push D-

pad(Ent) to enter the repeater group selection mode.
#1 Push D-pad( ) to select the desired repeater group

(01 to 30), and then push D-pad(Ent).
• The selected repeater group is displayed on the RE-
PEATER LIST EDIT screen.
9-29
Example:
"JP1YYY G" is
entered.
☞ Continued on the next page.