Menu Items And Default Settings - Icom ID-51A Advanced Manual

Previous view
16
MENU SCREEN

■ Menu items and Default settings

NOTE: The default settings shown below are for the USA version.
The default settings may differ, depending on your transceiver version.
In this item, set the repeater duplex offset and the channel tone or code options.
DUP/TONE...
Offset Freq
Repeater Tone
TSQL Freq
Tone Burst
DTCS Code
DTCS Polarity
Digital Code
* The default value may differ, depending on the frequency band (selected as the Main band before entering the
Menu screen) and the transceiver version.
In this item, set the scan options.
Scan
Pause Timer
Resume Timer
Temporary Skip Timer
Program Skip
Bank Link
Program Link*
*
See page 16-20 for details of the preset values.
RANGE OR VALUE (Default is shown in bold)
0.000~0.600.00*~59.995
67.0~88.5~254.1
67.0~88.5~254.1
OFF or ON
023~754
Both N, TN-RR, TR-RN or Both R
00~99
RANGE OR VALUE (Default is shown in bold)
2sec~10sec~20sec or HOLD
0sec~2sec~5sec or HOLD
5min, 10min or 15min
OFF or ON
A:□ ✔ ~Z:□ ✔
16-4
DESCRIPTIONS
Sets the frequency offset for duplex (re-
peater) operation.
Selects the tone frequency used to ac-
cess the repeaters.
Selects the tone frequency for the Tone
squelch or the pocket beep function.
Turns the Tone Burst function ON or OFF.
When this setting is ON and you transmit
a signal which superimposes the CTCSS
tone or subaudible tone, the squelch tail
noise of FM mode is suppressed on the
RX side.
Selects DTCS (both encoder/decoder)
codes for DTCS squelch or the pocket
beep function.
Selects the DTCS polarity for the DTCS
squelch or the pocket beep function.
Selects the digital code for the Digital
Code squelch function.
DESCRIPTIONS
Selects the scan pause time. When re-
ceiving signals, the scan pauses accord-
ing to the scan pause timer.
Selects the scan resume time from a pause
after the received signal disappears.
Selects the Temporary Skip Time. When
the time is set, specified frequencies are
skipped for this period during a scan.
Turns the Program Skip Scan function ON
or OFF for a VFO mode scan.
Selects banks to be scanned during a
Bank Link Scan.
Sets the link function for the program scan
edge channels.