Dedicated Ilo Management Module - HP apollo 4200 gen9 Maintenance And Service Manual

Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 33).
3.
Remove the access panel
4.
Remove the PCI riser cage (on page 36).
5.
Remove any existing expansion board from the riser board
6.
Remove the PCIe riser board.
7.
To replace the component, reverse the removal procedure.

Dedicated iLO management module

WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 33).
3.
Remove the access panel
4.
If installed, remove the rear drive cage
5.
("Access panel" on page 49).
("Access panel" on page 49).
("Remove a rear drive
("Expansion board" on page 59).
cage" on page 37).
Removal and replacement procedures 67