Power up the server.
15.
After installing the DIMMs, use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities
UEFI System
Dedicated iLO management module option
To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 17).
4.
If installed, remove the PCI air baffle (on page 20).
5.
Remove the system air baffle (on page 21).
6.
Open the slot cover retainer and remove the PCIe blank.
7.
Utilities" on page 101) to configure the memory protection mode.
("HPE
Hardware options installation 68