Dedicated Ilo Management Module Option - HP ProLiant DL160 Gen9 User Manual

Install a hot-plug power input module into power supply bay 2.
b.
Reconnect all server cables that were disconnected to access the removed power supply.
11.
Reinstall all server components that were removed to access the removed power supply.
12.
CAUTION:
all bays are populated with either a component or a blank.
Install the access panel (on page 22).
13.
Do one of the following:
14.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 17).
15.

Dedicated iLO management module option

For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
Remove the PCI riser cage (on page 23).
5.
To prevent improper cooling and thermal damage, do not operate the server unless
("Installing the server into the rack" on page 30).
Hardware options installation 82