Grasp and lift the rear drive cage out of the chassis.
c.
Remove the drive backplane.
7.
To replace the component, reverse the removal procedure.
Removing the two-bay SFF rear drive cage backplane
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 33).
3.
Remove the access panel
4.
Disconnect all cables connected to the drive backplane.
5.
("Access
panel" on page 49).
Removal and replacement procedures 93