Remove The Server From The Rack - HP apollo 4200 gen9 Maintenance And Service Manual

Remove the terminal block connector from the power input module.
c.
Remove the power input module.
d.

Remove the server from the rack

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
WARNING: This server is very heavy. To reduce the risk of personal injury or damage to the
equipment:
• Observe local occupational health and safety requirements and guidelines for manual
handling.
• Reduce the weight of the server by removing the drives and power input modules before
installing or removing the server from the rack.
• Obtain adequate assistance to lift and stabilize the server during installation or removal.
Hewlett Packard Enterprise recommends that a minimum of two people are required for
installing or removing the server from the rack. A third person might be required to help
align the server if the server is installed higher than chest level.
• Use caution when installing or removing the server from the rack; it is unstable when not
fastened to the rails.
Removal and replacement procedures 33