Expansion Board - HP apollo 4200 gen9 Maintenance And Service Manual

Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
7.
If disconnected, connect the Smart Storage Battery cable.
8.
Install the access panel.
9.
Install the server into the rack.
10.
Power up the server.
11.

Expansion board

WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all expansion slots have either an expansion slot cover or an expansion board installed.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 33).
3.
Remove the access panel
4.
If you are removing an expansion board installed in the PCI riser cage, remove the riser cage
5.
("Remove the PCI riser
Disconnect any internal cables that are connected to the expansion board.
6.
Remove the expansion board.
7.
("Access panel" on page 49).
cage" on page 36).
Removal and replacement procedures 59