Dedicated Ilo Management Module Option - HP ProLiant DL180 Gen9 User Manual

Dedicated iLO management module option

For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
To install the component:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 22).
o
Remove the access panel (on page 24).
4.
Access the rear panel
5.
Using a flat screwdriver, toggle the knockout to loosen it, and then pull it out of the chassis.
6.
If an expansion board is installed in the primary PCI riser cage, remove the board.
7.
("Access the product rear panel" on page 24).
Hardware options installation 102