Hpe Flexible Smart Array P840Ar Controller - HP apollo 4200 gen9 Maintenance And Service Manual

M.2 SSD enablement board removal from the system board
o
M.2 SSD enablement board removal from the PCI riser cage
o
To replace the component, reverse the removal procedure.

HPE Flexible Smart Array P840ar Controller

WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 33).
3.
Remove the access panel
4.
If installed, remove the rear drive cage
5.
("Access panel" on page 49).
("Remove a rear drive cage" on page 37).
Removal and replacement procedures 65