Konica Minolta bizhub c650 User Manual page 487

Utility mode
Parameter
Density Ad-
justment
Image Stabilization
Paper Separation Adjustment
Color Regis-
tration Ad-
just
Gradation
Adjustment
Line Detec-
tion
Trail Edge Adjust
*1
Appears when Finisher FS-608 is installed.
*2
Appears when finisher is installed with punch kit.
*3
Appears when Z folding unit is installed.
C650
Description
Thick 1/1+–Yellow Adjust the image density for printing on thick pa-
per or OHP transparencies. The density can be
Thick 2/3/4–Yel-
adjusted separately for each color (yellow, ma-
low
genta, cyan and black for a color image and the
black image density). The higher the setting, the
Thick 1/1+–Ma-
darker the density.
genta
Adjust the setting for yellow, magenta, cyan and
Thick 2/3/4–Ma- black between -5 and +5.
genta Adjust the setting for "Black Image Density" be-
tween -2 and +2.
Thick 1/1+–Cyan
Thick 2/3/4–Cyan
Thick 1/1+–Black
Thick 2/3/4–Black
Black Image Den-
sity
Perform an image stabilization if the image is in-
correct, even after the gradation levels have been
adjusted.
• Image Stabilization Only:
Perform a normal image stabilization.
• Initialize + Image Stabilization:
Select when a good result was not achieved
after "Image Stabilization Mode" was select-
ed.
Adjust the paper position where the two sides are
separated (between -2.0 mm and 2.0 mm) during
double-sided printing.
Color Registration Adjust the color registration if color shifts can be
Adjust (Yellow) seen in the print result.
Color Registration
Adjust (Magenta)
Color Registration
Adjust (Cyan)
Image Stabiliza- When adjusting the gradation levels, first press
tion Only the [Start] key to perform image stabilization.
Copy Adjust the gradation levels if there are changes in
the color gradations of the print image. The ad-
justment is made with stress on increasing the
number of images stored in the memory.
Printer (Gradation) Adjust the gradation levels if there are changes in
the color gradations of the print image. The ad-
justment is made with stress on the gradations in
images.
Printer (Resolu- Adjust the gradation levels if there are changes in
tion) the color gradations of the print image. The ad-
justment is made with stress on the reproducibility
of text and lines.
Prior Detection Select whether or not a warning appears when the
Setting left partition glass is dirty, and specify the dirt de-
tection level. The dirt detection operation is per-
formed before and after scanning a document
using the ADF.
Detection While Specify the level at which dirt is detected when
Feeding Setting scanning a document using the ADF.
• Do not remove:
The operation to remove lines is not per-
formed.
• Remove:
The operation to remove lines is performed.
Adjust shifting if it can be seen at the trailing edge
of the print result.
11
Default Setting
0
0
0
0
0
0
0
0
0
Image Stabilization Only
0.0 mm
-
-
-
-
-
-
-
Yes
Warning Display:
TYPE 2
Detection Level: Std.
1
-
11-26