Konica Minolta bizhub c650 User Manual page 263

Troubleshooting
Symptom
Finish- The finisher cannot be used.
er
The pages cannot be stapled.
The staple is incorrectly posi-
tioned by 90 degrees.
The pages that were fed out
were not uniformly loaded
and the punched holes or sta-
ples are incorrectly posi-
tioned.
Even though a Punch setting
was selected, holes are not
punched. (when the punch kit
is installed on the finisher)
Z fold- The Z folding unit does not
ing unit operate.
If any message other than those listed above appears, perform the operation described in the message.
If the problem is not corrected after the described operation is performed, contact your service
representative.
C650
Possible cause
Is no power supplied to the con-
nector?
Have the staples run out?
Is the staple position correctly
specified?
Is the paper curled?
Is there a gap between the lateral
guides in the paper tray and the
sides of the paper?
Did the message "Empty punch
scraps box." appear?
Is the power supply plug inserted
correctly into the outlet?
Remedy
Check that the cord is correctly in-
serted into the connector.
Replace the staple cartridge. (See
p. 8-21.)
Specify the desired position for
stapling. (See p. 2-62.)
Remove the paper from the paper
tray, turn it over, and then load it
again.
Slide the lateral guides in the paper
tray against the sides of the paper
so that there is no gap.
Empty the punch scrap box. (See
p. 8-33)
Correctly insert the power supply
plug into the electrical outlet.
4
4-68