Power Supplies For The Cisco Nexus 2224Tp Fex - Cisco Nexus 2000 Series Installation Manual

Cisco Nexus 2224TP FEX
Figure 2-26
1
Note For a fully dedicated 10-Gbps bandwidth through a M1 Series 32-port 10-Gigabit Ethernet I/O module
(either the N7K-M132XP-12 or N7K-M132XP-12L), connect each FEX to one port in a set of four
shared ports on the module (you connect each set of shared ports to one FEX). If you are using the M2
Series 24-port, 10-Gigabit Ethernet I/O module (N7K-M224XP-23L), you can connect the FEX to any
of its ports for a fully dedicated bandwidth. If you are using the F2 Series 48-port, 10-Gigabit Ethernet
I/O module (N7K-F248XP-25), use the connectivity rule order (connect the same port numbers for each
port group (for example, if you connect ports 1 and 2 of a port-group, then connect the same ports of
another port group).
For information about the transceivers and connectors that you can use with these ports, see the
"Transceivers and Connectors Supported by the Cisco Nexus 2224TP FEX" section on page

Power Supplies for the Cisco Nexus 2224TP FEX

The Cisco Nexus 2200 Platform FEX chassis have two slots for front-end AC or DC power supplies that
have port-side exhaust or port-side intake airflow. These chassis are fully functional with one power
supply, but you can install a second power supply for power redundancy. You can install any of the
following power supplies in those two bays:
•
•
•
•
Caution Make sure that all of the fan tray and power supply modules use the same airflow and have the same
color designation on the front. Otherwise, the switch can over heat and shut down,
For information on these power supplies, see the
section on page 2-14
Cisco Nexus 2000 Series Hardware Installation Guide
2-30
Port Numbering on the Cisco Nexus 2224TP FEX
1 3
2 4
1- and 10-Gigabit Ethernet downlink ports,
numbered 1 through 24
AC power supply with port-side exhaust airflow (N2200-PAC-400W)
AC power supply with port-side intake airflow (N2200-PAC-400W-B)
DC power supply with port-side exhaust airflow (N2200-PDC-400W)
DC power supply with port-side intake airflow (N2200-PDC-350W-B)
and the power supply specifications in
Chapter 2 Using a Fabric Extender with a Cisco Nexus 7000 Series Switch
5 7 9 11 13 15 17 19
6 8 10 12 14 16 18 20
1
2 10-Gigabit Ethernet uplink ports, numbered 1
through 2
"Power Supplies for the Cisco Nexus 2248TP FEX"
21 23
22 24
Appendix B, "Technical Specifications".
1 2
2
2-31.