Fan Tray For The Cisco Nexus 2232Pp Fex; Transceivers Supported By The Cisco Nexus 2232Pp Fex - Cisco Nexus 2000 Series Installation Manual

Cisco Nexus 2232PP FEX

Fan Tray for the Cisco Nexus 2232PP FEX

The Cisco Nexus 2232PP and 2232TM FEX use the same fan tray, which you can order with either
port-side exhaust airflow (N2K-C2232-FAN) or port-side intake airflow (N2K-C2232-FAN-B).
Make sure that all of the fan tray and power supply modules use the same airflow direction and have the
Caution
same color designation on the front. Otherwise, the switch can over heat and shut down,
For more information on this fan tray, see the
page 2-19
descriptions, see

Transceivers Supported by the Cisco Nexus 2232PP FEX

The Cisco Nexus 2232PP FEX supports SFP+ Ethernet optical and copper transceivers and optical FEX
Transceivers (FETs) for up to eight fabric uplink connections to the following Cisco Nexus 7000 Series
switch I/O modules:
•
•
•
•
You must use the same transceivers on both ends of the same uplink cable.
To get the fully dedicated 10-Gbps bandwidth through a M1 Series 32-port 10-Gigabit Ethernet I/O
Note
module, connect each FEX to one port in a set of four shared ports on the module (you connect each set
of shared ports to one FEX) and use the shared mode on the I/O module. If you are using the F2 Series
48-port 10-Gigabit Ethernet I/O module (N7K-F248XP-25) or the M2 Series 24-port 10-Gigabit
Ethernet I/O module (N7K-M224XP-23L), you can connect the FEX to any of its ports.
The Cisco Nexus 2232TM FEX also supports RJ-45 connectors for up to 32 downlink connections to
hosts.
Table 2-8 Supported Transceivers and Connector for the Cisco Nexus 2232TM FEX Uplink Interfaces
Transceiver or
Connector
FET-10G
GLC-LH-SM
GLC-SX-MM
GLC-T
SFP-10G-LR
SFP-10G-SR
Cisco Nexus 2000 Series Hardware Installation Guide
2-26
and the fan tray specifications in
Appendix E,
F2 Series 48-port 10-Gigabit I/O module (N7K-F248XP-25)
M1 Series 32-port 10-Gigabit Ethernet I/O module (N7K-M132XP-12)
M1 Series 32-port 10-Gigabit Ethernet I/O module with XL option (N7K-M132XP-12L)
M2 Series 24-port 10-Gigabit I/O module (N7K-M224XP-23L)
Table 2-2 lists the transceivers supported by this FEX for its uplink and downlink connections.
Fabric Host
Cable Interface Interface
Type (Uplink) (Downlink) Comments
Optical X –
Optical – X
Optical – X
Copper – X
Optical X X
Optical X X
Chapter 2 Using a Fabric Extender with a Cisco Nexus 7000 Series Switch
"Fan Tray for the Cisco Nexus 2232TM FEX" section on
Appendix B, "Technical
"LEDs".
10 Gigabit FEX transceiver
Gigabit SFP transceiver
Gigabit SFP transceiver
Gigabit SFP transceiver
10 Gigabit long range transceiver (up to 6.2 miles [10 km])
10 Gigabit Short range transceiver (up to 984 feet [300 m])
Specifications". For LED