Power Supplies - Cisco Nexus 2000 Series Installation Manual

Chapter 1 Using a Fabric Extender with a Cisco Nexus 5000 Series or Cisco Nexus 6000 Series Switch
You can order the Cisco Nexus 2248TP-E FEX with AC power supplies that have port side exhaust or
port side intake airflow for cooling or DC power supplies that offer port side exhaust airflow. The port
side intake airflow components have a black stripe on their fan side surface for easy visual identification.
The port side exhaust airflow components do not have a black stripe.
Be sure that all of the power supply and fan tray modules in the same chassis have the same airflow
Caution
direction and that the air intake for those modules is positioned on a cool aisle. If you install a module
that uses a different direction of airflow from the other modules in your system, you will see an error
message. If you position a chassis with its modules taking cooling air from a warm aisle, the switch can
over heat and shut down.
If one power supply is installed in the chassis, but the other power supply slot is empty, you should use
a blank filler panel (part number N2200-P-BLNK) to cover the empty slot.
power supply filler panel.
Figure 1-18
1
For power supply specifications, see the
supply, see the
see
Fan Trays
The Cisco Nexus 2248TP-E FEX has one fan tray that is hot swappable during operations. Depending
on the arrangement of hot and cold aisles in your data center, you can order port-side exhaust airflow to
position the fan side of the FEX chassis in a cold aisle or port-side intake airflow to position the back of
the FEX chassis in a cold aisle.
with the Cisco Nexus 2248TP-E chassis.
Blank Power Supply Filler Panel for the Cisco Nexus 2200 and Cisco Nexus 2300
Platform Chassis
1
2
Handle
"Removing and Installing Power Supplies" section on page
Table E-1 on page E-2.
2 Ejector latch
"Power Specifications" section on page
Table 1-4 lists the part numbers for each of the fan trays that you can use
Cisco Nexus 2000 Series Hardware Installation Guide
Cisco Nexus 2248TP-E
Figure 1-18 shows a blank
B-1. To replace a power
4-16. For LED descriptions,
1-15