Supported Transceivers And Cables - Cisco Nexus 2000 Series Installation Manual

Chapter 1 Using a Fabric Extender with a Cisco Nexus 5000 Series or Cisco Nexus 6000 Series Switch
Figure 1-20
1
1
2
To replace a fan tray, see the
descriptions, see

Supported Transceivers and Cables

The Cisco Nexus 2248TP-E FEX supports SFP+ Ethernet transceivers. The enhanced
Small-Form-Factor Pluggable (SFP+) 10-Gigabit Ethernet transceiver is a bidirectional device with a
transmitter and receiver. It has a 20-pin connector on the electrical interface and duplex LC connector
on the optical interface. Currently, the Cisco Nexus 2248TP-E FEX supports the short-range SFP and
long-range SFP transceiver. Copper interface cables are available for use with the 10-Gigabit Ethernet
SFP+ transceiver. For details see, the
Cisco Nexus 2248TP
The Cisco Nexus 2248TP is a stackable 1 RU 17.2-inch (45 cm) deep FEX that supports 48 1000-TX
host-facing (downlink) ports and 4 10-Gigabit SFP+ network-facing (uplink) ports. You can order it with
port side exhaust or port side intake air cooling, and with AC or DC power supplies.
You can use this FEX with the Cisco Nexus 5000 Series switch. The Cisco Nexus 2248TP is managed
and configured by the upstream switch. The FEX software ships with the Cisco Nexus 5000 Series
switch software. The FEX downloads the software image from the switch the same way that a module
would download it from the supervisor in a modular chassis.
This section includes the following topics:
•
•
Port-Side Intake Airflow Fan Tray for the Cisco Nexus 2248TP-E FEX
2
3
Captive screws (2)
Black stripe indicates port-side intake airflow
"Removing and Installing the Fan Tray" section on page
Table E-1 on page
Chassis, page 1-18
Ports, page 1-19
1
3 Status LED
E-2.
Cisco Nexus 2000 Series Fabric Extenders Release Notes.
Cisco Nexus 2000 Series Hardware Installation Guide
Cisco Nexus 2248TP
4-21. For LED
1-17