1.
Load the media onto the roll shaft.
Media having an outward curl
Press in to fit on securely.
Adjust the end cap to a position of 110 to 130 mm
(4.3 to 5 in.).
* When using media having a width of 2,540 mm
(100 inches) or more, be sure to position the
media at 110 mm.
* The scale on the media gauge is useful for ad-
justing the position.
Reinforcement pipe
Use this when loading media that has a width of 1,880
mm (74 inches) or wider. It reduces sagging of the
roll media.
Downloaded From ManualsPrinter.com Manuals
Hexagonal wrench
(large)
Roll media
End cap
Spacer
2-2 Loading and Cutting Off Media
Printed surface
Reinforcement pipe
Roll shaft
110 to 130 mm (4.3 to 5 in.)
End cap
Reinforcement pipe
Press in to fit on securely.
Hexagonal wrench
(large)
End cap
Media
Chapter 2 Operation
27