Setting The Marker Displays - Panasonic AJ-HPX2000 Operating Instructions Manual

Setting the Marker Displays

The center, safety zone, safety zone area and frame
markers may be set to ON or OFF, along with
specifications of the marker types. To set and select
markers, go to the VF MARKER screen from the VF page
and select the appropriate options.
For directions on navigating the menu, see [Setting Menu
Options] (page 153).
# < VF MARKER >
MKR:A
TABLE :A
CENTER MARK :1
SAFETY MARK :2
SAFETY AREA :90%
FRAME SIG :4:3
FRAME MARK :OFF
FLAME LVL :15
Marker Check Screen Displays (MARKER SELECT button function)
The viewfinder can display a screen that allows you to view
the marker settings of the unit.
Pressing the MARKER SELECT button on the camera-
recorder switches the marker indication as follows.
Marker A > Marker B > No marker
If the menu option FRAME SIG is set to 16:9 as the
information of Marker A and 4:3 as the information of
Marker B, then the 16:9 and 4:3 view angles can easily be
checked with the button, as required.
Checking Return Video Signal in the Viewfinder
The viewfinder displays the return video signal input to the
GENLOCK IN connector while the RET button at the lens
is held down.
To enable this capability, select CAM RET for the menu
option RET SW. This option can be found in the <SW
MODE> screen, which is accessible from the CAM
OPERATION page.
MARKER SELECT button
Adjustments and Settings for Recording : Viewfinder Screen Status Displays
Note
The indication MKR:A at the upper right of the screen
shows the current indication status. To view TABLE B,
press the MARKER SELECT button. This changes the
indication to MKR:B, allowing you to view the settings.
Markers
Center
The view angle specified through the menu
option FRAME SIG is displayed.
< SW MODE >
#
RET SW :R.REVIEW
S.BLK LVL :-10
AUTO KNEE SW :ON
SHD.ABB SW CTL :ON
COLOR BARS :SMPTE
S.GAIN OFF :L/M/H
DS.GAIN OFF :DS.GAIN
D.ZOOMX2 :ON
D.ZOOMX3 :ON
D.ZOOMX4 :ON
RC CHECK SW :R.REVIEW
Safety zone
79