Panasonic AJ-HPX2000 Operating Instructions Manual page 182

MIC/AUDIO2
Items/ Adjustable
Data Saved Range
FRONT MIC ON
POWER OFF
– C U F –
REAR MIC ON
POWER OFF
– C U F –
MONITOR STEREO
SELECT MIX
– C U F –
–40dB
FRONT MIC
LEVEL –50dB
– C U F –
REAR MIC –50dB
–60dB
CH1 LVL
– C U F –
REAR MIC –50dB
CH2 LVL –60dB
– C U F –
REAR LINE IN 0dB
LVL +4dB
–3dB
– C U F –
AUDIO OUT 0dB
LVL +4dB
–3dB
– C U F –
HEADROOM 18dB
20dB
– C U F –
WIRELESS ON
WARN OFF
– C U F –
The ____ in the Adjustable Range column indicates the
preset mode.
182 Menu : Menu Description Tables
Remarks
Select the phantom power supply for the
front microphone.
Select the phantom power supply for the
rear microphone.
When OFF is selected, no phantom
power is supplied even if the REAR
AUDIO CH1 or CH2 switch is set to +48.
When the MONITOR switch is set to ST
(stereo), select the signal format for the
monitor output.
Select the front microphone input level.
Select the rear microphone input level.
Select the rear microphone input level.
Select the rear line input level.
Select the audio output level.
Set the headroom (standard level).
Select whether or not to enable the
alarm to trigger for poor wireless
receiver reception.
TC/UB
Items/ Adjustable
Data Saved Range
TC MODE DF Set the time code mode.
DF: Drop frame.
NDF
NDF: Non drop frame.
Note
When the camera-recorder operates at
50 Hz or in 24P or 24PA mode, the non-
drop frame is always used.
– C U F –
UB MODE USER Select the user bits mode.
TIME USER: Select UB value set in the LCD
DATE
TIME: Select
EXT
TCG
DATE: Select local date and time (2 last
FRM RATE
REGEN
EXT:
TCG: TCG value enters UB.
FRM RATE:
Select the shooting information (e.g.
frame rate) for the camera. For more
information, see [ Frame rate
information recorded in user bits ]
(page 58).
When clips recorded in Native mode
are played back, the frame rate
information recorded in users bits in
the VAUX range is output.
REGEN: Read out value stored in the
Note
When the camera-recorder is in 720P
mode, FRM RATE is always selected.
– C U F –
Remarks
section.
local time (hours,
minutes, seconds).
digits of year, month, date, time).
When "CAM" , "VIDEO", or
"SDI" is selected in REC
SIGNAL on the SYSTEM MODE
screen, the user bits input to the
TC IN connector are recorded.
When "1394" is selected, the
user bits of signals input to the
DVCPRO/DV connector
recorded.
If reading fails, USER value is
retained.
card and record value
continuously.
are