Panasonic AJ-HPX2000 Operating Instructions Manual page 146

5. P2 Card Fully Recorded
Display window All 7 bar indicators for remaining MEDIA
capacity start blinking.
indication
This lamp will illuminate continuously until an
WARNING lamp
operation is made after recording.
This lamp will flash 4 times every second
Tally lamp
until an operation is made after recording.
Viewfinder The END indicator blinks.
This tone will sound continuously until an
Warning tone
operation is made after recording.
Warning The P2 cards are recorded to maximum
description capacity.
Recording/
playback The recording stops.
operation
Delete the clips in the P2 card or insert a
Countermeasures
new P2 card.
6. Image Sequence Error (24P, 30P, 25P)
"E-40" appears in the time code display field.
Display window
indication
Blinks 4 times per second.
WARNING lamp
Blinks 4 times per second while recording
Tally lamp
continues.
The REC WARNING indicator lights up.
Viewfinder
Beeps 4 times per second while recording
Warning tone
continues.
There are abnormal conditions in the image
Warning
sequence of the 24P, 30P, or 25P mode.
description
Recording/
Images can be recorded and played back,
playback but some frames may be dropped or the
sequences of TC and UB may shift.
operation
Confirm the recording/playback operation after
turning OFF the power supply once and then
Countermeasures turning it on again. If the error is not corrected
after executing this procedure, contact the
dealer.
146 Maintenance and Inspections : Warning System
7. Recording Error
"00:00:00:11" appears in the time code
Display window display field. Even after recording is stopped,
indication this display continues to blink until the next
operation is performed.
Blinks 4 times per second while recording
WARNING lamp
continues.
Blinks 4 times per second while recording
Tally lamp
continues.
The REC WARNING indicator lights up.
Viewfinder
Beeps 4 times per second while recording
Warning tone
continues.
This indicates a failure either in the P2 card
recording or the recording circuit. This is
Warning
displayed when attempting to record clips
description
where the total quantity exceeds the upper
limit (1000 pieces) for a single P2 card.
The recording may stop or continue.
Recording/
playback
operation
Restart recording. Or, turn the power OFF
Countermeasures and turn it ON again, before starting
recording.
8. Low Wireless Signal Reception
Display window
No display.
indication
Blinks 4 times per second. (During pause
WARNING lamp
and recording)
Blinks 4 times per second while recording
Tally lamp
continues.
The WIRELESS RF indicator lights up while
Viewfinder
recording continues.
Beeps 4 times per second while recording
Warning tone
continues.
Warning
This error indicates poor wireless audio
description reception conditions.
Recording/
Continues to operate without receiving the
playback
wireless microphone signal.
operation
Check the microphone power supply and the
Countermeasures
reception status of the wireless receiver.