Resetting Menu Option Settings To Defaults; Lens File; How To Provide Lens Files - Panasonic AJ-HPX2000 Operating Instructions Manual

Resetting Menu Option Settings to Defaults

The menu settings can be reset to their defaults.
To reset the settings to their defaults, select the menu
option READ FACTORY DATA in the <INITIALIZE> screen,
which is accessible from the FILE page.
All settings will be reset to their defaults.
Note
This operation does not delete the scene file, lens file, and
the information stored as the user data.

Lens file

The built-in memory of the unit stores eight sets of lens
files.
On the SD memory card, eight titles for eight sets of lens
files in a table (total 64 sets) can be written.

How to provide lens files

Adjustment of white shading
For the white shading adjustment, refer to [Adjusting the
Lens White Shading] (page 102)
Adjustment of the flare
Using the menu operations, open the <LENS FILE ADJ>
screen from the MAINTENANCE page and adjust the flare
in the LENS R FLARE item, the LENS G FLARE item and
the LENS B FLARE item.
# < LENS FILE ADJ >
RB GAIN CTRL RESET:ON
LENS R GAIN OFFSET:+000
LENS B GAIN OFFSET:+000
LENS R FLARE
LENS G FLARE
LENS B FLARE
Example of the chart for flare adjustment
0.1H
92 Adjustments and Settings for Recording : Handling data
:000
:000
:000
0.1L
< INITIALIZE >
# READ FACTORY DATA
WRITE USER DATA
The following data are recorded on the lens file.
Title name
White shading correction value
Flare compensation value
RB gain offset correction value
Adjustment of gain offset
For correcting changes in white balance that may occur
when replacing the lens.
1
Mount the lens as standard on the unit.
2
Shoot the grayscale chart with appropriate lighting
(2000 lx, 3200 K are preferable).
3
Set the WHITE BAL switch to the "A" position.
4
Adjust the lens aperture so that the white window at
the center of the grayscale chart is about 80%.
5
Push the AUTO W/B BAL switch to " AWB " to adjust
the white balance automatically.
6
Measure the signal level of RGB by using the
waveform monitor (WFM).
7
Replace the lens to one where a lens file is provided.
8
Adjust the lens aperture so that the signal level of Gch
isthe same signal level as the one obtained in
above.
9
Using the menu operations, open the <LENS FILE
ADJ> screen from the MAINTENANCE page and set
the RB GAIN CTRL RESET to ON.
10
Adjust the signal level of Rch to be the same as Gch
in the LENS R OFFSET item.
11
In the same way, adjust the signal level of Bch to be
the same as Gch in the LENS B OFFSET item.
6