Warning System; Warning Description Tables - Panasonic AJ-HPX2000 Operating Instructions Manual

Warning Description Tables

If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the
WARNING lamp, lamps inside the viewfinder and a warning tone.
Note
The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors
occur simultaneously a higher priority indication will be triggered. The [WIRELESS RF], however, may not be indicated,
depending on the menu setting.
1. System Errors
Display window
The error code lights up.
indication
WARNING lamp Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
The SYSTEM ERROR indication and the
Viewfinder
error code light up.
Warning tone Beeps continuously.
Warning An error in the reference signal or the
description communication.
Recording/
playback The operation stops.
operation
Please confirm [ Error Codes ] (page 148)
Countermeasures
and consult your distributor.
2. Card removal error
Display window
Error code E-30 blinks.
indication
Blinks 4 times per second.
WARNING lamp
Tally lamp Blinks 4 times per second.
The "TURN POWER OFF" indicator lights
Viewfinder
up.
Continues to beep.
Warning tone
The P2 card being accessed has been
Warning
removed, resulting in an error in the internal
description
memory of the camera-recorder.
Recording/
playback Cannot be performed.
operation
Turn off the power to the camera-recorder. If
Countermeasures there is an error in a clip on the removed P2
card, repair the clip.

Warning System

3. Battery Empty
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning
description
Recording/
playback
operation
Countermeasures Replace the battery.
4. Write-protect
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning
description
Recording/
playback
operation
Countermeasures
All 7 bar indicators for battery remaining
capacity start blinking.
Lights up.
Blinks once per second.
The BATT LED lights up.
Beeps continuously.
The battery has run out.
The operation stops.
All 7 bar indicators for remaining MEDIA
capacity start blinking.
This lamp will illuminate continuously until an
operation is made after recording.
This lamp will flash 4 times every second
until an operation is made after recording.
The WP indicator lights up.
This tone will sound continuously until an
operation is made after recording.
The inserted P2 cards are write-protected.
Recording is disabled.
Disable the write-protect or replace the P2
card.
Maintenance and Inspections : Warning System
145