Panasonic AJ-HPX2000 Operating Instructions Manual page 33

Shooting
White/Black Balance Adjustment to Recording Comple-
tion
For shooting, follow the steps below.
1
Select a filter according to light conditions.
2A
When the white balance is saved:
Position the WHITE BAL switch to [A] or [B].
2B
When the white or black balance is not saved and
you have no time to adjust the white balance:
Position the WHITE BAL switch to [PRST].
This adjusts the white balance against the filter
according to the position of the FILTER control.
2C
If the white balance is adjusted on the spot:
Position the WHITE BAL switch to [A] or [B] and shoot
a white test subject so that it appears at the center of
the screen. Then, follow the steps below to adjust the
white balance.
1. Press the AUTO W/B BAL switch toward [AWB] to
adjust the white balance.
2. Press the AUTO W/B BAL switch toward [ABB] to
adjust the black balance.
3. Press the AUTO W/B BAL switch toward [AWB] to
adjust the white balance again.
For directions on making adjustments, see [ Adjusting
the White Balance ] (page 45) and [ Adjusting the Black
Balance ] (page 48).
3
Point the camera at your subject to adjust the focus,
and zoom.
4
To use the electronic shutter, set the shutter speed
and operation mode.
For more information, see [ Setting the Electronic
Shutter ] (page 49).
5
Press either the REC START/STOP button, REC
button on the handle or VTR button at the lens to start
recording.
During recording, the REC lamp in the viewfinder
stays illuminated.
6
To stop recording, press either the REC START/STOP
button, REC button on the handle or VTR button at
the lens.
The REC lamp in the viewfinder goes out.
Operation Buttons
During recording, all operation buttons (REW, FF, PLAY/
PAUSE, STOP) are disabled.
White/Black balance adjustment to recording completion
3 1 4 5, 6
Recording and Playback ：Basic Procedures
2C 2A, B, C
33