Panasonic AJ-HPX2000 Operating Instructions Manual page 19

24
1
2
3
11
4
12
14.
SAVE ON/OFF switch
Used to select the power supply method for each
output section.
ON: The output selected through the menu option
SAVE SW is power-saved. This option can be
found on the OPTION MODE screen on the
SYSTEM SETTING page.
OFF: Power saving is canceled.
Note
The ON/OFF switch does not function during record-
ing. The ON/OFF status changes after recording is
completed.
15.
VIDEO OUT (output signal selector) switch
Changes the mode of the signals output through the
VIDEO OUT connector.
HD SDI : HD SDI signals are output. When the
camera-recorder is in SD mode, SD SDI
signals are output.
SD SDI : SD SDI signals are output. (Signals are
down-converted in HD mode.)
VBS ： Composite video signals are output. (Signals
are down-converted in HD mode.)
16.
VIDEO OUT CHARACTER switch
This switch controls the superimposition of characters
onto the video output from the VIDEO OUT connector.
ON: Characters are superimposed.
OFF: Characters are not superimposed.
For types of characters, see [ Settings of signals output
from VIDEO OUT connector ] (page 81).
17.
VIDEO OUT (video signal output) connector
This connector outputs video signals. The video
signals linked to the settings of
switch, 16. VIDEO OUT CHARACTOR switch and
19.OUTPUT SEL switch are output from here.
10 9 8
16 19
14 6 13
5 7
15. VIDEO OUT
Parts and their Functions ： Shooting and Recording/Playback Functions Section
34
21 22 23
20
36
35
15
17
33
32 18
18.
MON OUT (monitor output) connector
Used to output down-converted (analog composite)
signals for the monitor. The video signals linked to the
setting of the OUTPUT SEL switch are output from
here. Through an internal menu option, the characters
can be superimposed independently of the VIDEO
OUT connector. For more information, see [ Settings of
signals output from MON OUT connector ] (page 82).
19.
OUTPUT SEL (output signal selection) switch
Used to switch the signals output from the VIDEO
OUT and MON OUT connectors.
MEM: Video from the camera is output during
recording or when recording is paused or
playback signals are output from the P2 card
during playback.
CAM: Video from the camera is output constantly.
OFF: Video is not output, and the camera-recorder
operates in power-saving mode.
Note that the audio output is synchronised with the
video.
For types of video outputs, see [ Settings of signals
output from VIDEO OUT connector ] (page 81) or
[ Settings of signals output from MON OUT connector ]
(page 82).
Notes
During recording, this switch does not switch output
signals before stopping the recording operation.
When CAM is not selected through the REC
SIGNAL menu option, the output signals are the
same as for MEM even if the switch is set to CAM.
The menu option REC SIGNAL is found in the
SYSTEM MODE screen on the SYSTEM SETTING
page.
25
26
27
28
29
31 30
19