Table of Contents
Advertisement
Warning system
If an error is detected immediately after the camera is turned on or during an operation, the error is indicated with the <WARNING> lamp, tally lamp,
alarm, etc. Deal with the error by following the indications.
Warning list
@
NOTE
t "Reduced wireless audio reception" (page 206) is not displayed when set to the [AUDIO] menu → [INPUT SETTINGS] → [WIRELESS WARN] →
[OFF].
t Card access lamp does not flash even a warning occurs when set to the [OTHERS] menu → [LED] → [ACCESS LED] → [OFF].
1 System error
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
2 Card removal error
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
3 Battery end (low voltage input)
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
4 High temperature error
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
5 Card end
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Chapter 10 Maintenance — Warning system
Does not display.
Flashes four times per second.
Flashes four times per second.
All card access lamps flash four times per second in orange.
[SYSTEM ERROR] is displayed.
Sounds continuously.
Reference signal error or communication error.
The current operation will stop.
Consult your dealer.
Does not display.
Flashes four times per second.
Flashes four times per second.
All card access lamps flash four times per second in orange.
[TURN POWER OFF] is displayed.
Sounds continuously.
An error occurred in the camera because the expressP2 card being accessed was removed.
The current operation will stop.
Follow the message to turn the power off once and turn the power on again. Ensure that there is no error in the clips on
the ejected card, and repair the clips as necessary.
Seven battery charge level bars flash.
Lights.
Flashes four times per second.
All card access lamps flash four times per second in orange.
The [BATT] lamp is illuminated if the viewfinder has the [BATT] lamp. [EMP] flashes in the battery charge level display.
([%] flashes for batteries with information about its remaining capacity.)
Sounds continuously.
The battery has run out.
The current operation will stop. The power is turned off in approximately five seconds.
Change the batteries.
Does not display.
Flashes four times per second.
Flashes four times per second.
All card access lamps flash four times per second in orange.
[HIGH TEMPERATURE] is displayed.
Sounds continuously.
The internal temperature of the camera has risen exceeding the expectation.
The current operation will stop. The power is turned off in approximately five seconds.
Turn on the power again and confirm the recording by playing it back. If the problem persists, consult the dealer.
Seven remaining memory card capacity level bars flash.
Lights.
Flashes four times per second.
All card access lamps flash four times per second in orange.
[END] is displayed in the remaining memory card capacity display.
Sounds continuously.
There is no more remaining memory card capacity.
– 205 –
Advertisement
Table of Contents
