B7.2 Port Setting; B7.3 Pbx Interface Parameters; Port Setting Menu - Panasonic KX-TVP200 Installation Manual

B7.2 Port Setting
To access the proper menu for Port Setting, follow the menu path as shown:
System Administration Top Menu-1-6-2

Port Setting Menu

To access the proper menu Port Setting Menu for the selected port, follow the menu
path as shown:
System Administration Top Menu-1-6-2-Port No.(1-12)
Table B-38
Parameter
Flash Time
CPC Signal
Disconnect
Time
Dial Mode
B7.3 PBX Interface Parameters
Three separate parameters are used to program the VPS for optimal signalling and
performance with the PBX.
B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS
Value Range
(Default)
1. 100 ms Specifies the duration of the flash (recall) signal that the
2. 300 ms VPS will send to the PBX. See the PBX manual to
3. 600 ms determine the correct value.
4. 900 ms
(100)
1. None Specifies the minimum time necessary to detect an
2. 6.5 ms interruption in the CPC (Calling Party Control) signal
3. 150 ms received from the PBX. The VPS is able to determine
4. 300 ms that the line has been disconnected when it detects an
5. 450 ms interruption of the CPC signal.
6. 600 ms
(6.5)
1-8 s Specifies the length of time the line will temporarily be
(2) unavailable after a call has ended.
1. DTMF Specifies the dial mode for DTMF (touchtone) or Pulse.
2. Pulse 10 pps If Pulse is specified, pulse speed (10/20 pps) must be
3. Pulse 20 pps selected.
(DTMF)
Note: This setting only affects outward dialling from the
VPS. The VPS can only receive DTMF (touchtone)
signals.
Description/Function
Installation Manual 265