Panasonic KX-TVP200 Installation Manual page 88

4.3 CONNECTING THE VPS WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD612
f)
Repeat steps c, d, and e until all extension numbers are entered.
Conditions:
6.
Connect the jack assigned in Step 4 to the VPS.
7.
Connect your personal computer to the VPS and start your communication software (i.e.,
HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
8.
Turn the power switch off at the VPS and set the Rotary Switch to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the Rotary Switch to position 5 will default the Voice Processing System,
resulting in a loss of all user programming and voice messages (except User 1 and
User 2 prompts).
9.
Turn the power switch back on at the VPS and wait approximately 7-8 min while the system
initialises.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
•
•
•
•
Screen output:
CARD TEST...
SYSTEM SETUP...
1...
11... 12... 13... 14... 15... 16... 17...
•
•
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
** ON LINE MODE **
88 Installation Manual
No 2 jacks on the system can have the same
extension number. If you try to enter a number that is
already assigned, you will hear an error tone. Each
digital extension connected provides 2 Voice Mail
ports and must have 2 different extension numbers
assigned.
The Power Indicator light goes on.
The Power Indicator light begins to flash.
"CARD TEST" is displayed on the screen.
"SYSTEM SETUP" is displayed.
2... 3... 4... 5...
The VPS tests the CPU board, the hard disk drive, and
the CO cards as "SYSTEM SETUP..." is displayed.
Active ports are displayed on the screen.
6... 7... 8... 9... 10...