Panasonic KX-TVP200 Installation Manual page 223

Table B-8
Parameter
Message
Scanning with
Information
Prompt Mode
Remote Call
Forward to CO
Delete
Message
Confirmation
Authorization
for Message
Notification
B3 SYSTEM ADMINISTRATION—SETTING COS (CLASS OF SERVICE) PARAMETERS
Value Range
(Default)
1. Yes
2. No
(No)
1. System
2. User 1
3. User 2
(User 1)
1. Yes
2. No
(No)
1. Yes
2. No
(No)
1. Yes
2. No
(Yes)
Description/Function
If set to "Yes", the VPS adds the message sender's name
and the recording date and time to the message during the
message scan.
Specifies the language used for voice prompts.
Note: If User 1 is specified as Prompt Mode but not
recorded by the Message Manager, the VPS will
automatically play the factory-recorded System prompts in
English. By default, User 1 prompts are not recorded.
If set to "Yes", Remote Call Forwarding can be set to an
outside (CO) line; the Message Manager can program his
extension from a remote location to forward various types of
calls to either "Telephone No.1" or "Telephone No.2"
(preprogrammed in the Mailbox Setting), or to any other
telephone number.
Note: The Remote Call FWD to CO feature is available if
DPT Voice Mail Integration is activated with a Panasonic
KX-TD series telephone system.
Important Note: With respect to PBX programming, it is
possible that "Call Forward to CO" is disabled. To enable
VPS Remote Call Forwarding, the KX-TD1232, for example,
must be programmed properly. For the COS of the
extensions whose calls are to be forwarded to an outside
(CO) line, enable the following: [504] Call Forward to
Outside Line.
If set to "Yes", the VPS requests confirmation from the
mailbox owner before erasing a message left in the mailbox.
If set to "No", the message is erased immediately.
If set to "Yes", the Message Manager is able to utilise the
Message Waiting Notification feature. The sub-parameters
to be set include Beeper Callback No. Entry Mode, MWL
Notification for Unreceived Message, and Device
Notification for Unreceived Message. If set to "No", sub-
parameters cannot be assigned.
Installation Manual 223