Panasonic KX-TVP200 Installation Manual page 89

Voice processing system
Hide thumbs Also See for KX-TVP200:
Table of Contents

Advertisement

4.3 CONNECTING THE VPS WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD612
10.
Change the PBX type in the VPS programming menu in the following sequence.
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number := ______
Screen output:
Programm - Hardware Setting - PBX Interface Parameters - Dialing Parameters Menu
PBX Type [Other]
1. Other Manufacturers 2. KXT series
Enter the Model Number
1. T308 2. T616 3. T1232/TA series 4. T96 5. T336
6. TD816 7. TD1232/612 8. TD500 9. Reserved
Possible causes of the message: "DPT Interface Connection is not Established"
Table 4-3
The PBX is not a KX-TD series system. Since
the VPS is configured to communicate with the
KX-TD1232, this message will always appear
when connecting to another type of PBX.
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected.
The PBX is a KX-TD series but does not have
the proper level of software required to support
DPT Integration.
The PBX is not programmed properly to support
DPT Integration.
System prompts [>] are displayed on the screen. Press ENTER.
Screen output:
Go to the PBX type selection menu,
By selecting your terminal type [1] or [2] and press ENTER,
Select [1] and press ENTER
Select [6] and press ENTER
Select [3] and press ENTER
Select [1] and press ENTER
Select [2] (and press ENTER)
Select [7] (and press ENTER)
Escape the programming menu by entering Backslash Key until System prompt
[>] comes to be visible.
Check the LED on the VPS unit. If the light is on, the DPT connection between VPS
and PBX is established.
If the LED is flashing, the DPT connection cannot be established.
Cause
Remedy
Connect a KX-TD series PBX
and set the PBX type by using
Quick Setup (see
CUSTOMISING THE
SYSTEM).
Confirm the cabling is
connected as described in
INSTALLATION.
Consult your dealer
or use Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
Installation Manual
89

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents