Pri And Ip Qsig - Toshiba CTX100-S Programming Manual

302 PRI and IP QSIG

Prerequisite Program:
The PRI (RPTU, BPTU) and IP QSIG (BIPU-Q) interface cards need to have a number of assignments for
defining its operation. These include assigning which channels are available for use and the location of the
D-channel or signaling channel. The D-channel exists on the circuit assigned in this command. Also, a
number of optional functional capabilities also need to be enabled or disabled.
For BIPU-Q channel groups, parameters 01~04 must be configured, all other parameters should remain at
default. All parameters should be configured for ISDN. Many of these are normally set to default.
Note PRI ILGs and OLGs are assigned using
be set to 0.
1. Complete the
Record Sheet"
2. From the Program Menu, click
Trunk > ISDN > PRI.
3. Enter Channel Group number
...or click one of the following
buttons:
• List – View a summary list of
programmed Trunks.
• Create – Assign a new Trunk
with default settings.
• Copy – Enter an Channel
Group number and click
Copy to make a new Trunk
assignment with settings
copied from the Channel
Group entered.
• Delete – Delete an Trunk
(Trunks 1~128 for CTX670 and 1~32 for CTX100).
4. Enter data.
5. Click Submit.
F
IELD
Channel Group
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
100 page 4-1
"PRI Trunks
on page D-29.
D
ESCRIPTION
Channel Group Number.
Assign the proper PAD levels to channel groups in Programs 107, 108 and 114.
These levels are critical for ISDN and IP QSIG speech levels, as well as Quality Of
Service. Refer to the CTX Programming Manual guide line to set these levels.
Possible values: 1~32 (CTX100), 1~48 (CTX670 Basic), 1~128 (CTX670 Exp),
"Call-by-Call" on page 6-29. Therefore, ILG and OLG must
(default = no value)
Trunks
ISDN
5722
6-25