Step 3: Set Up Modem Connection (Optional) - Toshiba CTX100-S Programming Manual

Installation

Step 3: Set up Modem Connection (Optional)

Step 3: Set up Modem Connection (Optional)
Step 3A: Connect CTX WinAdmin PC to Strata CTX Modem
Connect an RJ11 cable from your PC modem to an active phone line or RSTU port. See Figure 3-4.
Local CTX
WinAdmin PC
Remote CTX
WinAdmin PC
Figure 3-4 CTX WinAdmin Modem Interface Connection
CTX WinAdmin PC Modem to CTX Modem Call Setup – CTX Programming and Operation
• Direct ring connection over CO lines
• DID lines: in PRG 309, assign "Built-in Modem" as the Audio Day1, Day, and/or Night destination
type.
• DIT ground/loop start lines: in PRG 310 assign "Built-in Modem" as the Day1, Day2, and/or Night
destination type.
• Direct Ring when connected to RSTU or DISA line: put "#19" in CTX WinAdmin Phone Number
dial string.
• Transfer a CTX WinAdmin call to the Strata CTX modem from a CTX Auto Attendant or telephone
After receiving the call from the CTX WinAdmin user, press
hang up after receiving CTX modem tone.
Note If calling an Auto Attendant put "xxxxxxx,,,,,,,, #19" in CTX WinAdmin Phone Number dial string.
Where "xxxxxxx" is the site phone number and each "," adds a three-second delay before dialing
#19 to connect to the modem.
Important!
3-10
RS-232 Cable
Modem
Modem
RS-232 Cable
Windows XP: Choose Step 3B; Windows 2000: Choose Step 3C.
Point-to-point TCP/IP
33.6 kbps v.34
Dial #19
CO Line CO Line
Telephone
Network
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
BCTU,
BECU or
Flash
ACTU/
or ROM
AMDS
Modem
RSTU
Time
Switch
CO Line
Circuit
Strata CTX
&QI7UQ
or hook flash and dial #19 then
and
RAM
5592