Voice Mail Set Up - Toshiba CTX100-S Programming Manual

Applications, Tips and Tricks

Voice Mail Set Up

The following steps/program sequences are provided as a guideline to programming System Voice Mail
settings.
Enter programming mode before step 1. Refer to
Note
each time you want to save your settings and press
Analog Ports
1. Program 100 "Card Slot Assignment"
2. Program 200 "Station Data"
• FB03 Circuit Type – Assigns Voice Mail to be assigned to PDNs associated with Voice Mail RSTU
circuits.
• FB15 Display DN – DN to be displayed and assigned to Hunt Group. Manually assign DNs and
equipment.
3. Program 209 "Station Hunting Group"
Group.
4. Program 218 "Station Hunt Group Assignment"
5. Program 579 "System Voice Mail Data"
Notes
FB10 Central Message Callback – Enter the node ID and hunt group for voice mail. Used for
centralized voice mail SMDI only.
DTMF – Message Waiting Call Back DN across QSIG TIE lines. DTMF integration uses the number
that displays in Program 200, field 15.
6. Program 580 "Voice Mail Port Data"
7. Program 803 "IO Logical Device Assignment"
Assign BSIS RS-232 port for SMDI.
System only provides Code 300 for SMDI. Code 301 is not supported.
Note
8. Program 804 BSIS RS-232 Serial Port setup.
9. Program 309 "Direct Inward Dialing"
• FB11 DNIS VMID Code
• FB15 DID/DNIS Number DTMF VMID
10.Program 318 "DID Intercept Assignment"
• FB11 VMID for DNIS Number
• FB15 DID/DNIS Number DTMF VMID
Strata CTX Programming - Part 4: Appendices 11/03
"Enter Program Mode"
on page 13-11. Assign the PCB for Voice Mail ports (RSTU).
on page 13-28. Verify FB1~FB4.
on page 13-46. Voice Mail Group is determined by the Hunt
on page
on page 13-89. Complete FB01~FB17.
on page 13-90. This is the collection of all ports.
on page
on page 13-59.
on page 13-67.
on page
before you move to the next step.
13-50.
13-94. You can add members to the hunt group.
A
+ROG
13-7. Press
A-1