Tracking Adjustment - Toro titan Z4800 Service Manual

12. If adjustment is completed, tighten the two jam nuts
against the adjustment rod nut.
13. Install the bolt and nut securing the seat stop cable
to the seat plate (Fig. 502).
Fig. 502
14. Remove the seat switch bypass wire and plug the
wire harness connector into the seat safety switch
(Fig. 503).
Fig. 503
15. Lower the machine to the ground.
2007 - 2008 Titan Z Service Manual
HYDROSTATIC DRIVE SYSTEM

Tracking Adjustment

If the machine turns right or left when the handles are
evenly pushed forward, adjust on the side opposite the
direction of turn (Fig. 504).
IMG-0591
A. Control Arm Shaft
B. Adjust Stop
Loosen the limiter stop screws that hold the adjust stop.
Move the adjust stop back until the machine drives
straight. Tighten the screws to lock the stop in place.
Adjust handles to make them parallel with each other, if
necessary.
IMG-0608
A
C
B
C
Fig. 504 IMG-0610a
C. Limiter Stop Screw (2)
7
7-41