Forward Tracking Adjustment - Toro titan zx Service Manual

8. Turn the adjustment nut (B) clockwise or counter-
clock wise until the tire has stopped rotating OR has
only a slight creep in reverse (RH side shown).
Note: If the tire is creeping in forward, turn the
adjustment nut clockwise, (tighten the nut).
If the tire is creeping in reverse, turn the
adjustment nut counterclockwise, (loosen the
nut) (Fig. 063) (RH side shown).
Fig. 063
9. Safely start the engine and run at full RPM.
9. Stroke the control handles in forward and reverse.
Move the control handles into the neutral position
and verify the rear wheels do not rotate forward or
reverse.
Note: A slight amount of reverse creep is
acceptable.
9. Readjust neutral setting if required.
10. Turn engine off.
11. Install the control cover(s) and torque the fastener to
specification – 5 ft-lbs. (7 Nm).
12. Remove the seat switch bypass jumper wire and
reconnect the seat switch harness connection.
13. Safely lower the unit and verify proper drive system
function.
Toro TITAN 2014 Service Manual
HYDROSTATIC DRIVE SYSTEM
B
PICT-3038

Forward Tracking Adjustment

Note: Always adjust the neutral setting before the
tracking adjustment.
Note: Do not make tracking adjustments on cold
hydrostatic drive systems. Safely warm the
drive system before making adjustments.
If the unit tracks or pulls to the RIGHT:
1. Remove the LH side control cover.
2. Turn the LH adjustment nut 1 full turn CLOCK-
WISE (tightening the nut).
3. Test drive unit and verify tracking.
4. If unit still pulls to the right, repeat steps 2 and 3
until unit tracks straight.
5. Install the LH control cover and torque the
fastener to specification – 5 ft-lbs. (7Nm).
If the unit tracks or pulls to the LEFT:
1. Remove the RH side control cover.
2. Turn the RH adjustment nut 1 full turn CLOCK-
WISE (tightening the nut).
3. Test drive unit and verify tracking.
4. If unit still pulls to the right, repeat steps 2 and 3
until unit tracks straight.
5. Install the RH control cover and torque the
fastener to specification – 5 ft-lbs. (7Nm)
(Fig. 064) (RH side shown).
Fig. 064
5
PICT-3038
5-5